| Login In | Careers | Sitemap |
 
 
 
   
     
Click here for more information on our
100th Anniversary Year (2011)
 
 
 
  Residential Services
Installation Requirements
Metering & Installation
Planning Your Service
Domestic Tariff
Renewable Energy Rider
Reading Your Meter
  Access Your Account
  Contact Info
  Emergencies:
(246) 626-9000


Customer Service
(246) 626-4300

PBX:
(246) 626-1800

Fax:
(246) 228-1396
 
   
     
  Residential Services  
 
Metering and Installation
 

» Metering
» Metering Sockets
» Single Meter Installations

METERING

Meters are installed by the Company to record the electrical energy and, in large installations, the maximum demand used by customers.

» BACK TO TOP

 

METER SOCKETS

Meter socket bases for loads up to, but not exceeding 200 amps, are to be supplied and installed by the customer. Customers are responsible for the proper maintenance of these socket bases and should have their electrician contact the Company to allow them access to carry out such maintenance. For individual services in excess of 200 amps the Company will provide a meter socket base and the required metering CTs.

Location of socket base on the building.

The meter should be placed in a location which will be accessible at all times to BLPC meter readers. In cases where it can be determined that the customer plans to fence the property, the customer is encouraged to have an underground supply and place the meter on the guard wall at the boundary of the property. In this case the meter should face outwards towards the roadway and comply with the Company’s requirements.

» BACK TO TOP

 

SINGLE METER INSTALLATIONS

a) Type of Socket Base - A 5 jaw socket is required for all 3 wire services with the 5th jaw connected to the neutral conductor.

b) Height of Socket Base - The meter socket should be at a height of about 1675 mm (5' 6") above finished grade. In underground installations where the metre is to be located on an external guard wall, the minimum allowable height is 1 meter. Figure 20 shows a typical metering installation for an underground service.

c) Wiring of Socket Base - The wiring in the socket base should be neat, not bulky, and connected as shown in Figure 19. Any excess wire in the socket base may prevent the meter from being properly inserted into the socket.

d) Secure Mounting of Socket Base - The meter socket base should be properly secured to the building.

e) Waterproof - The point at which the conduit enters the meter socket base should be properly sealed to prevent water from entering into the socket. All equipment installed outdoors should be designed for outdoor use as it will be exposed to the weather.

» BACK TO TOP

 
 
   
Customer Services | Business Services | Understanding Your Bill | Residential Services | Customer Tips |
| Watts New | FAQs | Corporate Information | Careers | Sitemap |
  ©Copyright The Barbados Light & Power Company Limited 2014 | Terms of Use | Privacy Policy |